电流变效应的研究及应用前景

本文介绍了电流变效应这种物理现象的原理及其工程应用．     

Automated flow-based anion-exchange method for high-throughput isolation and real-time monitoring of RuBisCO in plant extracts

In this work, a miniaturized, completely enclosed multisyringe-flow system is proposed for high-throughput purification of RuBisCO from Triticum aestivum extracts. The automated method capitalizes on the uptake of the target protein at 4 °C onto Q-Sepharose Fast Flow strong anion-exchanger packed in a cylindrical microcolumn (105 × 4 mm) followed by a stepwise ionic-strength gradient elution (0-0.8 mol/L NaCl) to eliminate concomitant extract components and retrieve highly purified RuBisCO. The manifold is furnished downstream with a flow-through diode-array UV/vis spectrophotometer for real-time monitoring of the column effluent at the protein-specific wavelength of 280 nm to detect the elution of RuBisCO. Quantitation of RuBisCO and total soluble proteins in the eluate fractions were undertaken using polyacrylamide gel electrophoresis (PAGE) and the spectrophotometric Bradford assay, respectively. A comprehensive investigation of the effect of distinct concentration gradients on the isolation of RuBisCO and experimental conditions (namely, type of resin, column dimensions and mobile-phase flow rate) upon column capacity and analyte breakthrough was effected. The assembled set-up was aimed to critically ascertain the efficiency of preliminary batchwise pre-treatments of crude plant extracts (viz., polyethylenglycol (PEG) precipitation, ammonium sulphate precipitation and sucrose gradient centrifugation) in terms of RuBisCO purification and absolute recovery prior to automated anion-exchange column separation. Under the optimum physical and chemical conditions, the flow-through column system is able to admit crude plant extracts and gives rise to RuBisCO purification yields better than 75%, which might be increased up to 96 ± 9% with a prior PEG fractionation followed by sucrose gradient step.     

玻璃芯片上温控微阀的制备和微流体控制性能研究

聚N-异丙基丙烯酰胺(PNIPAAm)在临界温度(32 ℃)附近会发生敏锐的相变, 导致其体积和表面亲疏水性的突变. 利用这种由温度刺激引起的体积变化, 可以控制微通道内微流体的运动状态. 本文以2-羟基-2-甲基-1-苯基丙酮为引发剂, 水-乙醇混合体系为溶剂, 在玻璃芯片通道内局部区域以紫外光诱导聚合PNIPAAm整体柱塞, 制备温控微阀. 系统地考察了聚合条件对该阀的形态和性能的影响. 在此基础上, 建立了一个芯片上的集成化单温控阀流动注射分析模型, 利用镁离子与荧光探针O,O'-二羟基偶氮苯的螯合荧光反应, 表征温控微阀的控流效果. 结果表明, 所制作的微阀温控效果良好, 在微流控领域有应用前景.     

Development and critical comparison of greener flow procedures for nitrite determination in natural waters

Two greener procedures for flow-injection spectrophotometric determination of nitrite in natural waters were developed and critically compared. Replacement of toxic reagents, waste minimization and treatment were exploited to attend the standards of clean chemistry. The flow system was designed with solenoid micro-pumps in order to minimize reagent consumption and waste generation. The first procedure is based on the Griess diazo-coupling reaction with sulfanilamide and N-(1-naphthyl)ethylenediamine (NED) yielding an azo dye, followed by photodegradation of the low amount of waste generated based on the photo-Fenton reaction. The second procedure is based on the formation of iodine from nitrite and iodide in acid medium in order to avoid the use of toxic reagents. For Griess method, linear response was achieved up to 1.0 mg L^− 1, described by the equation A = − 0.007 + 0.460C (mg L^− 1), r = 0.999. The detection limit was estimated as 8 μg L^− 1 at the 99.7% confidence level and the coefficient of variation was 0.8% (n = 20). The sampling rate was estimated as 108 determinations per hour. The consumption of the most toxic reagent (NED) is reduced 55-fold and 20-fold in comparison to batch method and flow injection with continuous reagent addition, respectively. A colorless residue was obtained by in-line photodegradation with reduction of 87% of the total organic carbon content. The results obtained for natural water samples were in agreement with those achieved by the reference method at the 95% confidence level. For the nitrite–iodide method, linear response was observed up to 2.0 mg L^− 1, described by the equation A = − 0.024 + 0.148C (mg L^− 1), r = 0.999. The detection limit was estimated as 25 μg L^− 1 at the 99.7% confidence level and the coefficient of variation was 0.6% (n = 20). The sampling rate was estimated as 44 determinations per hour. Despite avoiding the use of toxic reagents, the nitrite–iodide method presented worst performance in terms of selectivity and sensitivity.     

聚偏氟乙烯微孔膜的亲水化改性及功能化研究进展

聚偏氟乙烯(PVDF)微孔膜的亲水化改性方法有物理共混、化学共聚、表面涂覆、表面化学处理、表面接枝等几种。其中物理共混和表面涂覆法比较成熟且已获得应用，而PVDF微孔膜的表面化学处理、等离子体或光引发改性技术以及环境敏感性等将成为PVDF微孔膜的改性和功能化研究的主要方向。     

Lensless Fourier holography for digital holographic interferometry on biological samples

Digital holography as a tool for highly sensitive, interferometric non-destructive testing has several advantages compared to holographic measurements based on conventional storage media like an all-digital processing and a direct access to the phase of the object wave. Experimental results of interferometric investigations of heart valve bio-prostheses with a setup for lensless Fourier holography are presented which demonstrate that this technique is applicable to such biological samples with their wet and unstable surfaces. Limitations on size and resolution of the reconstructed object caused by the properties of the CCD sensor are discussed.     

多极板电流变阀应用于避震器之研究

以流动模式（flow mode)多极板之电流变阀（electrorheological valve)进行避震器阻尼力特性的研究。由于电极板的大小直接影响到流体流动的剪力及避雷器的阻尼力,因此使用多极板型式来探讨避震器的特性。设计有1－5个流道之并联及1－3个流道之串联多极板电流变阀的电流变避震器,并使用自制的电流变液进行实验。由研究结果显示,流动式并联极板之电流变避震器,一个流道之阻尼力最大,流道极板增加则阻尼力反而下降,而流动式串联多极板之电流变避震器之阻尼力则随极板数递增,故需要高阻尼力之避震器较适合使用串联多极板型式。     

阀切换在化肥分析专用多通道全自动气相色谱仪中的应用

阐述了阀切换在化肥专用多通道气相色谱仪中的原理、硬件、软件、流程和色谱图。现场使用表明,利用微机控制阀切换进行多点采样进样分析,能减少手动进样与人工处理数据的误差。     

在线中和富集及标准加入离子色谱法测定大气吸收液中的痕量阴离子

建立了大体积进样后的在线中和富集及在线标准加入离子色谱法,实现了对大气碱性吸收液中痕量氯离子、亚硝酸根、硝酸根、硫酸根的直接测定。比较了不同阀切换时间窗及在线中和柱的选择,确定了最佳的实验条件。利用戴安公司“谱睿”在线中和技术,通过Inguard H在线中和柱和CRD 200在线二氧化碳去除装置的共同作用,有效地去除了碱性吸收液中的OH~和CO2~3,使测定干扰降低到最小;通过大体积进样和在线富集,改进了样品的检出限,Cl~, NO~2, NO~3和SO2~4的检出限分别为17.5、171、34.7和42.4 ng/L;在线标准加入解决了痕量阴离子标准溶液的配制难题及NO~2低回收率对检测结果的影响。本方法实现了自动化分析,结果准确,重复性好,检测效率高,可用于常规离子色谱条件下无法测定的强碱性基体样品中痕量阴离子的准确测定。     

离子排斥色谱结合光度检测的水质监测系统用于测定离子型营养物（英文）

A unified ion-exclusion chromatography(IEC) system for monitoring anionic and cationic nutrients like NH + 4,NO 2,NO 3,phosphate ion,silicate ion and HCO 3 was developed and applied to several environmental waters.The IEC system consisted of four IEC methodologies,including the IEC with ultraviolet(UV) detection at 210 nm for determining NH + 4 on anion-exchange separation column in OH form connected with anion-exchange UV-conversion column in I form in tandem,the IEC with UV-detection at 210 nm for determining simultaneously NO 2 and NO 3 on cation-exchange separation column in H + form,the IEC with UV-detection at 210 nm for determining HCO 3 on cation-exchange separation column in H + form connected with anion-exchange UV-conversion column in I form in tandem,and the IEC with visible-detection based on molybdenum-blue reaction for determining simultaneously silicate and phosphate ions on cation-exchange separation column in H + form.These IEC systems were combined through three manually-driven 6-port column selection valves to select each separation column to determine selectively the ionic nutrients.Using this sequential water quality monitoring system,the analytical performances such as calibration linearity,reproducibility,detection limit and recovery were also tested under the optimized chromatographic conditions.This novel water quality monitoring system has been applied successfully for the determination of the ionic eutrophication components in sub-urban river waters.